Recent content by Hothead79

stock length rod?

Is this kit worth the $? eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices

It doesnt need to be pull start, i was planning on getting a mini starter for this one. But I was trying to keep it on gas if possible.

Thank its going to b a slow build, but the thin wallet will be worth it in the end! :thumbsup:

im thinking of starting to build a clone and id like to try and get 25-30hp on gas. already have a flat-top piston, ordered a .020 rod. I need ideas for the top end set-up, and id like a big cam, mayb a 356 or bigger lift cam and a matching set-up. Im building a bike to run 1/4 mile. any info is...

its not a leak around the intake, and its not a bent pushrod. its def not getting enough fuel so i ordered a bored out carb to try out. it may even just be air/fuel mixture at idle. idk im at a loss.

I have a clone with a header, filter, and a #90 jet. It wont run with the choke off and the plug is leading me to believe its running lean. Isn't the #90 jet big enough for the mods? :confused:

Howdy, i was wandering if any of the engine guru's on here have any idea how far you can bore a gx200 past stock? thanks in advance :thumbsup:

i high sided my bike doin bout 30-35 and only had a small spec of road rash. my helmet and jacket did there jobs!! just wish i had ridn boots cause i destroyed my right foot. Have fun but safety first:thumbsup: