Recent content by verk182

I ground down the caliper on the bench grinder. Problem solved!

I just put the Carlisle turf saver 15-6-6 on my sons blitz and it rubs on the brake caliper. :shrug:Any suggestions?

I think I got it. Several hot laps around the neighborhood and the chain is still on! I really like the way this 6.5 pulls my big ass around, must really haul ass modded like a lot of you have done. The stock governer setting seems to fit the type of riding we will be using it for, gets up to...

any tips on sprocket alignment? Got it all going and have tried eye balling it three times and each time the chain flys off! :confused:

I think I will just use the 2.8 tank, searched and found several threads on that subject. Might go cheap and dirty and use zip ties for now to mount the tank.:grind: We are going camping in 3 weeks and I just need a work horse. My sons blitz got worked over last spring break with the same...

Came home from work tonight to find a nice priority mail package on the front porch. Got the install kit from cjtmini, super quick shipping and so far so good. Hopefully have some time tomorrow to get it finished

PM sent

Anybody have a non CARB compliant 6.5 clone tank laying around that they don't need anymore? I could use one for my Blitz project, let me know if you have one.

I would like to find a non carb compliant tank to fit my blitz.

Forgive my ignorance, but what is wrong with the stock emulsion tube? Just asking because I am getting ready to make the swap.

Does anything need to be plugged after I pull all of the tubing?

Picked one up yesterday with the coupon in this thread, thank you for posting that. Now I just have to figure out a gas tank, the Cali version has that big old nasty gas cap on it.

do you still have the gas tank available?

I have been looking for several months now for another Blitz/Doodlebug and finally found one on craigslist. On the way home from picking it up I just happened to see a Harbor Freight and low and behold I got a clone for $89.99! I can only assume all the crap hanging under the cylinder and...

Dudly the o-ring worked out just fine, just took a little bit of tweaking to get it to seat perfect. Once again thank you for all of your sound advice, hopefully you and the mods can work out your differences.