Search results

Yeah, they are 1" tubing...

Not quite what you're looking for, but it has just been refurbished, runs great, has a minibike throttle setup and includes a clutch...

I'll measure them...

Yeah, there was a USPS rate hike last month, but I don't mind losing a few bucks on shipping...kinda like splitting the shipping cost with the buyer. Those handlebars need to be cut off and MIG'd or TIG'd back on with some sleeves inside the tubing... The brazing around the triple tree...

The wheel set is sold...thanks!

#2 is spoken for...thanks!

I'm guessing about $15 to MI... What would be a fair price if they were repaired properly, stripped and primed?

The fender is sold...thanks!

Yes...there are pics of this brand of caliper set up to use the sprocket as the rotor in the member's pics section of OldMiniBikes. But, if you're wanting one for a Li'l Indian with the OEM sprocket caliper setup, the mounting holes on this caliper are too far apart.

Interested in a Trail Blazer?

PM sent...

I doubt if it is...I think those have milled/recessed bolt slots for clearance over the bolt heads while repositioning the engine. This one is just a 1/2" thick billet version of a simple engine plate.

The kickstand is sold...thanks!

Thanks again George.

Is it in Chinese?

Yes...thanks for pointing that out...center peg frame.

:laugh:

It looks beautiful...nice work.

Damn, that's gorgeous!

It would be a little ironic to put a USA-made Comet TAV on a Chinese-made clone engine...