Search results

This is the one I found for my Clinton Panther...exit slot on the top and bottom

Soak with BP Blaster and uses the impact on mine

Michigan Facebook marketplace has a couple complete mowers

Made this one from a Simplicity Snowblower Chain cover model 524 I believe...they run 14" to 15 1/4" long depending on the year...can pick them up for $20-$30

Serial #10165 Rupp, have pegs and front fender, will be looking for the missing stuff. Is it a 1967?.. What HP engine would it had come with?

Delete

Decided to let someone else restore the Tote Goat...will be listing with the Tote Goat Research Book...or trading for Hot Rod stuff

Thanks, was about to go look at that same style of motor

Thought that wheel looked small....seeing a few 8hp for sale

I took all the non original stuff off it yesterday...keeping an eye out for a 6-7hp Briggs..undecided if I will add it to my project list

Good info, I did order the Tote Goat book...will look for a 7hp Briggs...

Someone put a tiller style clutch on it, cut a frame support for the motor, will weld in a section to get it back to a stock frame

Have the worm gear...missing brake caliper, original clutch...but see some are using a comet clutch

Will be looking for 780 parts, tank, seat, caliper, clutch..ect

Looking for 780 parts, gas tank, clutch, disc brake..let me know what you have...Roy

Unknown jack shaft , good Sprockets...$10 Lowell , MI

The chain guard was part of an old window box fan

Kohler 8.5 HP with electric start, Comet 44 clutch and converter, rear drum brake plus a disc brake on the jack shaft... probably will add lights next

Foot rest are factory repo clutch/ brake pads for a '41 Ford

Winter project, added the larger gas tank, rear fender, Clinton air breather, chain guard, second brake on the clutch and headlight, powder coated red metalic...built to take along to some car shows...a bit too tall to really ride...bummer