Search results

I moved the seat back to ride comfortable, Don’t be Haters…

Very nice fab work, not many on here are capable of that. I see you ended up using a different tank anyhow. I have the same mini and used a riser plate from OldMiniBikes, gas tank still fit easily. https://www.OldMiniBikes.com/torque-converter-riser-plate-with-hardware-tavplatev2.html

Do the motors currently run in this condition and how long have they been running? I would hope the installer of the billet rod rotated the crank assembly, if they had any knowledge they would have noticed a clearance issue.. Does the 79cc motor have oil in the crankcase?

He wasn't idling for 30 min,he stated after 30 I was idling and it would jump forward, but I believe you are correct. Disassemble your clutch and lube it before you buy a new one. It is already broke what do you have to lose.

I baffled as to why you ran new threads in the crank. I believe when you tapped the crank you took material out of the I.D. which weakened the crank nose and then you used too long of a bolt/ tapped to shallow and stretched the nose again and broke off the end on the crank. The original bolt is...

Our motto at work was " If ya can't beat it Heat it "

I just purchased the Mega Moto 80 frame with front suspension for just under $400 shipped. I like these as you have disc brakes. https://www.gopowersports.com/mega-moto-80-105-front-suspension-roller-frame/

Are you sure now you are asking the correct question, I answered your question as you posted it, you said tire.You sound like you are in over your head… It would be far easier to adapt the dirt bike swing arm as a whole( wheel,axle,disc brakes with mounting brackets, caliper)to the mini bike...

You need to find a donor bike and use that swing arm/wheel/disc brake and adapt it to your frame.

I believe these are the jets you need for the new Chikuni carbs being sold. Attached is a rough sketch of the K38 pilot jet in Chikuni's

Jets came from Ebay, the nose diameter is .030 too large will not go in the pilot jet hole. The thread appears to be different also. Back to the search

I guess this will work, found more 90 degree mounts and they race them.

I am next in line to purchase this and would like input if this will run in the long term.

I would take both chains off and replace them, while the chains are off check all rotating bearings for friction.

Saw this add for an unusual bike and how the motor is mounted. can you run the motor valve cover up? Wish I saw it 1st ..

Are you drilling out the governor hole to accept 1/8 npt pipe threads and then use a 3/8 hose barb to 1/8npt pipe? Again the purpose is to get oil mist to the rockers? Does the factory value cover have a build it check valve? This is how I am running now,is this good or bad? Thank for all the...

What are you using to adapt the governor hole to vent it to the valve cover,is a check valve needed? Thanks

No Amazon, $54 special. I will try the jets from Ebay,for $10 why not. Thank you.