i just finished swapping a 10hp Tecumseh from a snow-blower into my go kart. i fully cleaned the carb and have the throttle hooked up to carb with out governor. it starts easy and runs great but i cant get it to idle low enough to fully release the torque converter. if i turn the stop screw down...
Hey guys, I am changing the frame shape from the factory "suitcase shape" to stretched body with a taller front, somewhat chopper style. I am leaving the frame under the seat the same height. That means that I have to widen up the frame angle under the seat. Do I need a serious torch to heat...
Tonight me and some guy's are going for a mini ride. I want the doodlebug in tip top shape. I've installed the jackshaft aired up the tires (tires helped a ton) I also removed the air filter cover and drilled a buncha holes in it, and backed off the throttle stop. Can I adjust the governor, or...
I finally aquired the carb rebuild kit for my 3hp flathead Briggs on the Tote Gote. After installation and warming it up, it was running great. Idles much better than it used to. Then I installed the air filter.
My question is: Is it normal to have to adjust mixture (both idle and high...
Hey guys! My boy just bought his own green DB last night. He is really excited. He paid $150 cash for a brand new one (don't ask). I changed the oil before even starting the thing up. He has about five miles on it and we are going to change it again. We are riding it at "break in" speed...
I have an older style carb Briggs 3hp. The type of carb with the pullout choke. The motor ran alright at times and would just idle at other times. I put on a new gasket where the carb mounts to the block. Ran it around and seemed the same with good and bad running. Cleaned and adjusted the only...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.