hello I am tj-ro new from Whittier ca I have a powell challenger 2134-c the only reason I know that is I have been watching the site for a while now and enjoyed all the info thanks. I will send photos later.
I pulled the rear pulley/sprocket apart this morning, and one bearing is broken, and noticed the rear sprocket has curved forward teeth, is this normal and forged this way? I was checking out OldMiniBikes for replacement bearings but didn't really find a direct replace. I measured 1 -9/16 outside dia...
Hello. Some of you might be interested in my Powell Challenger frame restoration on You Tube. My frame had two cracks on the front cross member on each side of motor mount tongue, not at the welds but beyond that point, and both frame rails were bent and rusted out and worn at the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.