reduce

I recently posted a thread in the Strictly US Vintage forum of my 1967 Taco 22. I haven't painted it yet mainly because I'm not sure what color to paint it. I am considering painting it the correct color but purple has never been my favorite color. My question has to do with resale value. If...

So my engine is further modified and has blow-by smoke and oil coming out of the exhaust. At first the engine had a HUUGE amount of blow-by you would swear James Bond him self came by with his smoke screen. So I used the governor hole as a vent,drilled it open just a tad more, and the...

hello, I got a message stating i'm over my limit on pictures. how do I delete the old ones off ?///??? Ive figured how to delete the private messages, but not how to get rid of pictures that take up a lot of mb's

I was thinking to take flywheel to the machine shop to reduce the weight a little an gain some rpm faster, do any one with a Tecumseh motor has done that, or is a stupid ideas:grind:

I am looking to slightly reduce/delay the initial torque after putting in the 6.5hp HF motor. Would swapping the rear sprocket to a lower tooth count be sufficient? I am running a max-torque clutch. I weigh 170 lbs.

does anyone know if i can add something to it i.e. oils or something so i can run it in my tec (100hm) flattie? maybe some of the old hands know something that works- to be able to use AV 100LL aviation fuel and a mix ratio with something else to get it down to a useable 87 octane? :wink: anybody?