1 inch bi directional 10t clutch wanted

[debriscreator]

Can anyone point to where I can buy one or have one for sale? Please let me know. Thank you in advance.

 

[CarPlayLB]

A 10 tooth sprocket on a 1" shaft can only be run on an "outboard" style clutch. There is not enough room to make it bi-directional
https://www.OldMiniBikes.com/-40-41-420-chain-1-bore-10t-comet-scs-400-series.html
even assuming you are using 420 chain!

 

[debriscreator]

well that stinks. im trying to stick a bigger motor into an azusa frame and the clutch is just too far out for the chain. if i push the engine back to where it aligns its sticking way too far out the right side of the bike. i guess i have to use a smaller motor for this frame.

 

[danford1]

What engine is it? Can you swap in a 3/4" crank? You can have the 1" crank turned down to 3/4" and have a new key way cut
if it is special engine... Not sure what that would cost though.

 

[debriscreator]

its just an older briggs 8hp engine. nothin special. i think having it milled would probably cost more than buying a smaller engine wouldn't it?

 

[massacre]

How many teeth to run it inboard? Could you even that out with a bigger rear sprocket?

 

[debriscreator]

not sure what running it inboard means.. its a 10t sprocket from an azusa frame. i just wanted this build to be cheap and easy... looks like that won't be the case. lol

 

[O.J.Didit]

Call Max Torque, they can help.

O.J.

 

[massacre]

not sure what running it inboard means.. its a 10t sprocket from an azusa frame. i just wanted this build to be cheap and easy... looks like that won't be the case. lol

Meaning with the sprocket teeth inboard rather than outboard
And it’s never as easy as it seems
At least for me lol