3D printed factory air filter cover!

C

chriswh86

New Member
#1
#1
Hi all,

I have been excited lately getting the Baja up and running. I seem to be close now and I am starting to tackle some of the smaller projects. To start, I designed and printed myself a custom air filter cover for the factory setup on a 6.5hp clone Honda.

I added some text to both sides of the air box. I can swap to either side depending on my mood that day. A fun side and a 'Rebel' side.

Anyways, Enjoy the renderings and final print photos and I will put up some installed photos when the sun comes out tomorrow.

Cheers
Chris,

Renderings:
air box v11.png air box v111.png air box v1111.png air box v11111.png

And the final print:
1.png 2.png 4.png
 
C

chriswh86

New Member
#2
#2
Installed! I am pretty happy with it. Just need to clean up the lettering a bit and possibly paint the lettering. If I make another version I will reduce the height of the inside cylinder where the wing nut tightens down. It is holding the filter a couple mm high.

installed 1.jpg installed 2.jpg
 
You must log in or register to reply here.
Top