clone crankshaft needed?

[manco53548]

I scored a brand new never ran clone but the issue I soon found is the crank happens to be a short 20mm non keyed crank. is there a place that sells the crank with a 3/4" shaft keyed?

 

[C9H13NO3]

I scored a brand new never ran clone but the issue I soon found is the crank happens to be a short 20mm non keyed crank. is there a place that sells the crank with a 3/4" shaft keyed?

6.5 clone or 5.5 clone? I have a 6.5 clone crank I can send you for free.

It's only been run for a few hours.

 

[manco53548]

5.5 160cc :sad: I may have a lead on a briggs 8hp just hope its going to work. its coming from a tiller so who knows what shafts going to be on it. may be a long shaft

 

[mmisterbungl]

I have a crank for you. It's an OEM Honda 5.5HP crank

 

[manco53548]

are there any issues I thing I need to look for when I swap them?

 

[mmisterbungl]

are there any issues I thing I need to look for when I swap them?

issues? dont break anything:shrug:

 

[manco53548]

ok, so its like the old briggs MFH? JK I had read something about pulling the flywheel on one of the clones would create some sort of an issue. no idea unless its not keyed or something

 

[mmisterbungl]

as long as you line everything back up...which should be easy because the flywheel side has a key in it as well to line things up.

 

[65ShelbyClone]

I have a crank for you. It's an OEM Honda 5.5HP crank

Huh, I thought the cast cranks only came in GX140s.