M MegaDoodle New Member Jun 15, 2009 #1 Jun 15, 2009 #1 I have been doing searches for the past hour, can not find a thing.. After governor removal where did you relo your throttle linkage?
I have been doing searches for the past hour, can not find a thing.. After governor removal where did you relo your throttle linkage?
Strigoi Jun 15, 2009 #2 Jun 15, 2009 #2 http://www.oldminibikes.com/forum/honda-clone-engines/7132-clone-throttle-hookup-secrets.html what were you searching for? that thread took all of 10 seconds to find by putting in "throttle hookup" and searching in only the clone section.
http://www.oldminibikes.com/forum/honda-clone-engines/7132-clone-throttle-hookup-secrets.html what were you searching for? that thread took all of 10 seconds to find by putting in "throttle hookup" and searching in only the clone section.
BajaBlitz New Member Jun 15, 2009 #3 Jun 15, 2009 #3 here are a few samples -- sample or rear and front set-up Use a spring to return throttle to closed position. ;-) Last edited: Jun 15, 2009
here are a few samples -- sample or rear and front set-up Use a spring to return throttle to closed position. ;-)
M MegaDoodle New Member Jun 16, 2009 #4 Jun 16, 2009 #4 Strigoi.. you are too good at this... Thanks again man.. I told you I was a noob.. :doah: really though thanks again :thumbsup:
Strigoi.. you are too good at this... Thanks again man.. I told you I was a noob.. :doah: really though thanks again :thumbsup:
M MegaDoodle New Member Jun 16, 2009 #5 Jun 16, 2009 #5 Blitz.. also thank you. Immediate pictures are my favorite, I have a George Bush attention span.