Need SNOWCO forks

[huertagg]

Anyone have forks for sale? As you can see, mine are bent to shit.

 

[manchester1]

Easy to bend them back. Don't use heat. They are not bad at all. Just use a press. Or take them to a body shop with a large coffee and a 20.00 bill. They will hook you up.

 

[Lizardking]

You can try this method if you don't have a press.

 

[Mark G]

Are there any remnants of shock mounts being cut off on the front of the tubes? Some of those SnoCo's had an Earls type front end and those bends look about right.

 

[huertagg]

Are there any remnants of shock mounts being cut off on the front of the tubes? Some of those SnoCo's had an Earls type front end and those bends look about right.

I'll check

 

[huertagg]

Easy to bend them back. Don't use heat. They are not bad at all. Just use a press. Or take them to a body shop with a large coffee and a 20.00 bill. They will hook you up.

So like a standard 20 ton press?

 

[Mark G]

Now that I compare the two they look a little different:

 

[Hent]

If all else fails, I can make them. I don't do the smashed ends though.

Whats the distance between the forks?

 

[FOMOGO]

Stick them in a trailer hitch receiver and flex them back a little at a time. Just be patient and bend them cold.