I am using the stock header and muffler that comes with the Harbor Freight 212 Predator engine. It is like a square box muffler and there is no adjustability to its attachment. The alternative would be to buy a separate header pipe and attached muffler of some sort which would cost more than...
Was wondering if there were mounts that could be welded yet offer bolt holes so that foot pegs could be bolted to the frame and replaced when broken etc.
I have been riding some very rough trail lately requireing 1 or 2 mph speeds sometimes and it is hard to ride while sitting down at speeds slower than about 6 or 8 mph. Somehow when standing you can steer and balance like on a bicycle mountain bike or a real dirt bike motorcycle. I need the...
I am using the stock OEM muffler that came with the motor and when riding my Mini Baja my left inside thigh is very warm almost to the point
of pain unless I shift to an unnatural position on the bike. It looks like I have about a quarter inch space between the muffler shield and
the muffler...
Oh and forgot to mention.... When I first pulled the plug out the whole electrode and area inside the insulator was totally soaked in thick oil.
It has now made me aware of more tools and spares that I have to take along on my rides
1. spark plug socket and wrench or whatever to hold it...
Yes it was a hydraulic lock and it was definitely oil in the cylinder and not gas. I poured some gas into the cylinder and pulled the rope many times and the spray coming out was oily. the first pull right after taking the plug out had pure oil come out just like out of the bottle.
Anyhow I...
I was riding a thick trail sideways on a hill about two mph and put my foot down for support on the downhill side and it wound up
being a foot deep hole. I fell off the bike and tumbled down the hill while the bike remained inverted in the hole and ran about
10- 15 seconds before quitting...
Massacre - you seem to have misread or misinterpreted my comments and noted my opinion wrongly. I absolutely LIKE/LOVE mechanical governors for all those riders who do not understand they can blow the engine up like children and those who do not have the discipline or understand technically...
I should add as seen in the picture the bottom chain rubed slightly on the frame so I raised up just the rear of
the motor by one inch using washers to create more clearance for the chain. THAT made me have to fabricate
different length brackets for the muffler AND had to re-engineer the...
Charles S. Yes all helpful hints are appreciated especially tire mount 101. But did you read that the pros
at the tire shop had a difficult time. This tire happens to be six ply and very very stiff. I suggest you get one
and mount it just for the fun of it. I even bought the $45...
I'm sorry that is BS. Did you not notice that you said MPH and not RPM ? On the performance cars that CAN do 155mph (VERY SMALL percentage)
, they are limited to speed and not to RPM except for very few exotics. If you want to sit in neutral and rev the crap out of it till explosion you...
Grow up Harquebus. How's that. I doubt if you threw a handful of those plastic gears loose inside the crankcase that any harm would occur. Besides that the replacement cost of the engine is only $99 and if the unused timing gear only screwed up on one of every hundred motors assuming
it could...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.