1/4

1" extra lg housing 1/4 turn throttle $14.00 shipped. Each

Will be testing my new bike at the track and was curious to what the record is on a Minibike at the drag strip. Got a Dragbike style grudge race on September 17th at thunder valley here in noble Oklahoma and was wanting some kind of idea as to whether I'm slow or not. Hahaha Finally did a...

Over the years I've been a collector of nitro/electric Rc bikes . Lost count at 85 bike most vintage collectable . [url='http://www.oldminibikes.com/forum/attachment.php?attachmentid=58453'][img]http://www.oldminibikes.com/forum

I've got a couple different sizes of T-nuts I'm selling. 1/4" - 20 w/ 7/16" shank 1/4" - 20 w/ 5/16" shank 1/4" - 20 type E insert nut, 7/16" length Selling in lots of 50 and 100. $8 per 50 $15 per 100, shipped PayPal preferred.

I have a great running tec 3.5 hp with at 5/8" crankshaft. I want to tap it to fit a 1/4" bolt to hold on my clutch. I bought a tap and die set from Lowe's. My question is to tap to fit a 1/4" bolt, do I use a 1/4" drill bit followed by a 1/4" tap? I know it sounds so basic, but I only want...

$20 shipped to anywhere in the lower 48. note the flywheel key is 1/4" wide, must be an older part.

The hole on top of the motor where the throttle arm is....That's a 1/4 20 self tapping screw right? What about the governor gear hole? You know behind the flywheel I just knocked it out ...is that a 1/4 20 self,tapping,screw as well?

I'm looking for a Round Red Reflector for the back of a ARCO EZ-Rider I. I believe that it was 3 1/4" in Dia.

Been working for a week now and just about done with it . It will hold my Hobert 140 mig and my new Eastwood AC- DC tig welder . Also will hold two bottles, 100 percent argon and the 72-25 for the mig . Still have two finish the cable holders , the flat steel loops on the legs will have 1/4...

1/4 midget

Our 1/4 display at the PA auto show around 1978?

Our 1/4 Midget Rig 1978? Us kids all raced.