580

Impulse buy from eBay a while back, has great spark and compression. I’ve never put gas to it. It’s just been sitting on my shelf, looks like I’ll never do anything with it. Mounting plate included, but is unfinished. Looking to get 375$ or best offer shipped from south Louisiana PayPal preferred.

Breaks my heart to find a new home for this bike. Bought the 500 roller from Karl and decided to do something different for the engine, since the bike originally came as a kit with no engine. West Bend won out. I was referred to Frank Moore who built the 580 5 port. Frank ran and tested it...

Looking for a trumpet style exhaust header for a West Bend 580 motor. Anyone know where I can find one for a Build Off bike? Thanks.

Looking for a clutch for a west bend 580 9/16 shaft size--9 or 10 tooth gear or one i can change gear--thanks.

I'm looking for a complete West Bend 580 engine.

I am looking for some torque specs for a west bend 580 need to rebuild mine it has low compression please help!!!

anyone have anything on this lil guy

Can anyone show a picture of the throttle cable connection and connector hardware where it attaches to the engine? Thanks. Tom

"How To Hop Up Your West Bend" manual that Go Power published in 1960. Super cool and very sought after hop up manual for the west bend 580/700 fan. I only took photos of a few pages there are 90 pages packed with useful tuning and modification information- make your stocker run better, or go...

Been wanting one of these for a while now, Its a little dirty and I haven't heard It run yet....but that's OK it does turn over and has good compression. My good friend and brother by another mother Eric (CarPlay) is sending me a gasket set so that I can clean it up and check It out. No suped...

Looking for a open header, custom type for a West Bend 580 engine. What do you have ? Thanks in advance, ond.

I've got the reed cage, i just need a carb. prefer a good working but ill take a nasty one to rebuild if the price is good. help a guy out! thanks in advance!!

Hey guys I looking for ideas for an air filter. I don't want something that sticks out to far. The screw holes are 1-3/8" apart.

WANTED THESE ORIGINAL PARTS FOR A 1964 TACO FITTED WITH A HANGING WEST BEND 580 5 PORT ENGINE: 1) Short 4" round x 7" long gas tank. 2) Chain guard that covers PTO clutch sprocket to jackshaft sprocket. 3) Hand brake lever. 4) Air filter with single screw OR double clip type for WB 580 5...

This was on a West Bend 580 I had. What is it called? Thanks

Does anyone have the seal numbers, Pto & Ign. plate for the West Bend 580

I'm guessing anyone with an interest in them has already seen them. WB 580 V 5 engines don't come along often. Twins never, except this set that didn't sell the last time they were offered, but they are sure cool. West Bend 580 V-5 5 Port Vintage Go Kart Engines

http://pages.ebay.com/link/?nav=item.view&alt=web&id=121508125690 :hammer:

Hello everyone! A few days ago I purchased a used Manco 580-01 for $25.00 on craigslist. I tuned it up and got it running but I can't seem to figure out how to change the oil. There is no oil cap or dipstick anywhere on the bike. So I was wondering if anyone here knew anything about the...

Frame: from Bad Dog in Laguna Niguel. Engine:West Bend/Power Bee 580 w/ 2-speed jackshaft. Paint is Candy Apple blue.