convertor

I have a '71 Flying O with an HS40, missing torque convertor and jack shaft. Can someone help me with what OEM would have been? If the OEM is not available what would be a replacement? Thanks in advance

Hi- We tore apart the bike today and although it's all there, we're in need of some parts. Please let me know if you have advice or help where I can get these (I included parts from the OldMiniBikes website where I could find them): 1) carb kit for an automagic carb (Lawson products) for the 3hp...

Hello everyone I haven't been on here in a while. How has everyone been? I have a question. I Built my bike up can rod and all. I have a tav 2 on it and I'm thinking about switching to a clutch. What would be the advantages and disadvantages if I do so? I need more speed. I'm running 12 - 53 but...

Hi guys. I'm ordering a 6.5hp clone on money to start my mini bike project. Just wondering if I should use a centrifugal clutch, or a torque convertor. I've only had experience with centrifugal clutches, never torque convertors. I've tried to search but can't really find the pros and cons of...

Looking for a torque converter let me know what you have

So I got new 420 cc motor,went on Ebay and got 1 inch diameter torque convertor setup,says it fits clone motors ,but this one doesn't..The back of it hits the cooling fins on engine...What do I have to do to get it to work??It's hopefully going into my BadDog...

New to Minibikes and small motors and would like to know if installing a torque convertor system would increase top speed withot messing with the govenor. I'm sure this has been asked before but i've not had much luck searching through old threads.

Ill bump this thread until I get an answer. I really need some help here (background, skip if ur lazy) Alright. I have had a TAV2 for quite some time now. Probably two years. Over them two years my engine has been getting more and more modifications, causing a hellof a lot more torque, HP, and...

Used but in great shape big cat torque convertor #41 $100 plus shipping

Hi guys a little help and information needed on my drag mini bike.iv just had it all completed and took it for a run and after i reach a good speed the motor just doesnt want to rev any higher at all as tho its govened but its not.i was wondering does the tc limit the rpm off the engine at all...

:thumbsup: hey thanks for all the help my next question is about the tav system on this brooks model 7010 it looks to be complete but iam not sure , does anybody know what series system this is , or is it some type of jack shaft i want to know if its complete and what type of drive clutch i need...

I was wondering if this torque converter would work on my gx200 clone on doodlebug frame: affordablegokarts: Torque Converter If it would work on it, how much would it actully help with low end torque? I dont relly need top speed. Also, what header would you recomend for this? YouTube - 6.5...

This was on a minibike that had sat in the mud for years and the frame was rusted out totally and I cut it up so no one would get hurt on it . The motor still ran and the clutch worked but the driven is missing parts and I am not sure what kind it is to research what is missing from the driven...

Complete comet torque converter-$95 michigan-open to trades but perfer cash.

Very nice Tecumseh hs50 5 hp motor with torque convertor and nice shield , motor just was in the shop this spring and had the carb gone through and a complete tune up with a 100.00 price tag it now runs nice and smooth . this motor has the right hand corner fill tank for mini bikes and also...