due

Just got tired of losing fine thread nuts vibrating off and hunting down new ones no matter how tight even using lock washer? Put a piece of shrink tubing on end of bolt after puting nut on..it may loosen but wont fall off..thought I'd share tip i thought of yesterday :thumbsup: funny title...

I posted about the cables on my Super Bronc being frayed and got lots of suggestions. I want to say thanks to all that contributed. But I must give credit to Clint Stutts at Go Kart Galaxy. Harley's Papa suggested that I just go there and buy a replacement cable. I looked at the cable chart...

Thanks for dropping by! My old Stellar has a plate that clamps onto the forks between the upper and lower trees. It simply clamps on due to its curved edges that grip the forks. Mine has actually rubbed itself through on one side due to a broken weld between the fork and tree. Can someone help...

Does anyone have any YFM80 top end parts laying around? This is the little quad that I picked up for the granddaughter a few years ago. I pulled it out, fixed the flat tire, and got it running. Was just putting around and she stalled out. After pulling the head due to no compression, I found...

Though not totally sure year maybe late 60's early 70's due to the lack of lighting. Any input will help me nail it down. Thank you

Hi, I have a 10hp tecumseh I took off a generator to use on my big-wheel bike I'm building. I'd like to move the carb, as it's mounted on the end of a down-swept manifold(?). I'd like it to be higher, due to puddles, etc. Can I just eliminate the intake? I've seen other motors with the carb...