excited

Sadly the 3/4" jackshafts I ordered magically turned into 5/8" somewhere in transit :(

I took me 30 plus years to finally get my first mini bike....LOL...it only took me 2 months to get my 2nd..

I bought the first Scat Tracker and then the second for parts but it was so complete I decided I had better just restore it to!! They are both from 1973 and now running. Does anyone else have one of these?

I used to be on here as manco53548 well its been some time and that e-mail no longer exists so I had to join as manco53115 (yes i e-mailed the forum last week but i guess it didn't help) I have another manco kart that is an exact match to my other kart.. kids are already excited to get...

I bought an old Fox mini, and it came with an Hs40, and (what I think is) an old HS35 or HS40. I haven't found any numbers yet. The 35 has a lighting coil, but no flywheel and no compression. The HS40 is good (I think). The carb is pretty nasty. I was thinking of rebuilding it, but $20 for a new...

looking on cl this morning long island saw stellar frame for sale look and it's a rupp continental or something like that damn ! not only that last week same roller for sale for fifty bucks :out:

HPE cat dominator minibike mini bike make offer

So I've been trying to locate a cheap round gas tank for a kart of ours. Man are they expensive!! E-Bay was ungodly high. I ran across this snowblower with it's tank replaced with just what I'm looking for.(far from original) When I got there I was shocked at what a clean old Tecumseh powered...

After I got the "Fire bike" running my nephews were the first 2 to get to ride it. The thanked me for working so hard to get it running. Thank you all for the parts and advice. A guy on crags list has 2 frames and 2 running motors, clutch and a parts motor. He wants $95 they look ok. I scraped...

Hi all, I picked this up at a swap meet in NJ today. Not sure what it is. Pic from the side: A Pic from the back: Note the crazy handlebars! Any help would be greatly appreciated. I would like to buy new parts but will have these restored if need be. Don't mind the crates...

I'm starting to get excited about my project {now with a picture) I have been working on my FOX DB after getting a few needed parts and it is starting......just starting to come together. I can almost prep the frame for paint but right now we have sirens going off and a cluster of 3 storms...

Hi all, I am new to this forum and hobby for that matter. I just bought what I am pretty sure is a 1970's Arctic Cat SSS 2. It has all of the original pieces but I am looking for some new decals to put on it! And a couple small replacement parts like the tail light. Any information on my new...

I discovered the shaft is one inch!!!!:censure::doah::confused::sadcrying4: Is there anyone who can give guidance how to REDUCE this one inch shaft to a 3/4 or 5/8? Very depressing.