It looks like I am going to have to sell my 1970 SSSCAT. Its a complete orignal restore. Trying to figure it out what its worth. I have a price in my head, but would rather see what you Pro's can tell me. Its been in a collection for sometime. I have notice the Torque converter cover is cracked...
There is no section in the classifieds for "other"... I dont want to join another forum just to sell parts, so this will sit, if no one could use it...
I am mainly into other hobbies and im sure others are into more hobbies than just minibikes... so trying to see if anyone can use a nice...
hi,
i have this bird frame with taco uprs bars with springs and something else on the bottoms .but its straight powder coated and pinstriped.....200 plus shipping. :thumbsup:
Used Pac Mule fender (2) 22.00 each
New Pac Mule fenders (3) 32.00 each
repo bonanzs MX rear fender with bracket 42.00
2 original Bonanza MX fenders front and rear 75.00 for the pair fenders only no brakets
new Ruttman / Lil Indian fender 26.00
Motor off my 1960 Tote Gote located in Riverside, Ca $150 OBO
Pictures and see it running on Craigslist
Vintage Tecumseh H60 , tote gote motor.
Joe
Riverside, Ca
951-402-9735
This carb is actually called a Baroni/Tryton. It's the same as the carb I run on my gasser minibike motor. Carb is solid billet, and has a throttle bracket on it.
24mm venturi, with 27mm bore
$110 shipped, about 1/3 of the new price, slightly used
I'm selling this for a local guy. The motor is a Briggs Stroker 305, with a billet BN20 Head. The motor is 2.637" ARC stroker with a deck extended resleeved 3.500" bore. Motor makes about 45hp. To much to list!
He is asking $2500 local pick up only, fire it up and hit the throttle.
need to sell, buying a car soon so i need cash,
BRAND NEW genuine honda gx200 shortblock assembly.... $160 + shipping, shipping should be less then 10 bucks
18cc bare head, used... $25
genuine honda coil.... $15
Fan shroud, little dirty....$10
One mounting bracket has been drilled and bolted to the fender. And the fender has a bend on the lip of one end. Light rust and scratches. But still a hard to find fender. 38.00
The rear wheel is in decent conditon. The tire is bad. The sproket shows wear but usable. 65.00 The front wheel has a chip out of one side, and the other side shows scrapes and wear aswell. The Carlisle tire is in decent usable condition. 35.00 make me a offer.
Fresh chromoly sleeved gx200 block, Right now at 2.992" bore can go up to 3.080" bore if needed. Special machine work done to eliminate blown head gaskets up to 15.1 compression, kart track tested.
Instant 5+hp gain over standard bore motors
$310 shipped
Up for sale is my Baja Army Bike only because I want a 70s Enduro/Dual Sport Bike, but Im not giving it away! It has custom paint that is okay and burlap covered seat gives it the vintage army bike look!
Ive added the tav and a upgraded spring kit and the 60 dollar header to it also comes with...
I went through my storage the other day and found this clutch. It' setup for 3,800 stall and can go up to 4,300, or dwon to 3,500 clutch stall. it has a 14 tooth drum on it now, and comes with a extra 15 tooth drum. The disc are good, clutch is just a little dirty.
If it's not sold by...
The bike is near complete and original. It has a Artic Cat gas tank, and missing the clutch cover. Otherwise it runs and rides. Big Block lighted 5 H.P. The bike was made in Clinton, Michigan in the early 70's
800.00
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.