mill

So i have access to some storage in Cape Town. I bought my mill for R11000 and will probably only get R8000 for it second hand. Priced new there almost R20000. So i decided to keep the mill the lathe and my compressor . The guys at work made me up three crates. Only would be really...

what all does it take to do this? probably going throw this crank in with a std length billet rod, with flat top piston. will I have to mill the piston down? looked all over the site and couldn't find anything

I am starting a few projects this winter and I can't do the work myself, looking for someone that can mill and port small engine heads pretty cheap.

I'm in metro Detroit area looking for local machine shop to mill & port my GX200 head. Any Suggestions? I really don't want to spend a fortune. Thanks,

I have some kart hubs for the front wheels that I need the stepped area in the pic below milled down (approx 1/8") on two hubs so I can put a hub on either side of my wheel so the wheel looks more uniform side to side with the bearings being outboard on each side..

Well I bought a mini lathe last week and was talking to my brother who is a mechanical engineer , and we went over what a lathe could or couldn't do. His advice was a lathe is very versatile but has it's limitation what you need is a mill as well. So I went back to Princess auto and found a...

Anyone want to mill it for me? I would pay someone to do it but I thought I'd check here first.

I have 2 heads that Im going to mill in my machining class.. :evil_laughter: 1 of them is a briggs 5hp head. I was wondering how much I could take off without making it too hard to pull start? :blink: The other head is from a briggs 10hp and I had the same question about it except it's from an...

if you owned a mill and lathe, what mods could you do to your engine for more performance. I have a lathe now, and access to a mill while I look for one of my own.