ohlsson

This started out as one of those ideas where my son and I just sat around wondering if it would work and sketching it out...the next thing I knew we were building it ! We've all seen the Tom Thumb and Micro Bikes...not very practical being 6 inches off the ground. Or the 26" cruiser bikes...

Looking for a 1HP OHLSSON & RICE motor. There seemed to be a lot of NOS ones floating around in the past...NOS would be great or something in good running condition. Some have a gear reduction bolted onto them but I'm not sure if the crank is the same on those. PM me if you've got one or a...

Looking for a good ohlsson rice tank. Or some ideas for something similar. thanks Joe

I'm trying to get this engine to work in my Tom Thumb. The shaft is only 1/2 thick for the clutch. Does anybody know how to adapt this :shrug: I found this adapter that looks like it might work :out: The adapter goes from 1/2 inch to 3/4. Any help would be appreciated. Thanks.

O & R engine

Ok, so I was looking at my Ohlsson Rice that I have had since High School, I got 2 of them from my teacher for fixing him one, Well over 20 years ago. It seems that somewhere in time the Coil has got broken, and now needs replaced. So if anybody out there has a spare for a fair price, I sure...

Looking for a Ohlsson Rice or something like it for a Tom Thumb project. Cash in hand.

I just got my NOS Ohlsson and Rice engine and the instructions say to mix SAE 30 oil with the gas, my question is, wouldn't 2 stroke oil be better than SAE 30 oil? And if SAE 30 would that be detergent or non-detergent?

Need to adapt a 5/8 or 3/4 clutch to an Ohlsson rice 1hp 1/2 output shaft. Whats out there or custom?

Looking for a nice :drool: Ohlsson and Rice 3/4 or 1 hp. I'm willing to spend :deal: for the right engine.....

Small O&R steel gastank for use with silly looking minibikes like those pictured below. $60.00 Delivered: . . . .

make offers best offer will be accepted by friday