sensor

Adding a fuel level sensor to gastank

Tachometer with build in digital speedometer. Incl sensor.

Ok, I just swapped out my old 196cc baja engine with a new Rato 212cc from Canadian Tire (looks like Predator). Bolted in no problem, but when I went to disconnect the oil sensor I couldn't find it. All the videos and images that I could find online show a yellow wire coming out of the...

My engine will just shut off mid ride on my mini bike. Someone told me it was probably the low oil sensor. Can i just disconnect it or do I have to remove it completely?

What are you guys putting over the hole for the oil sensor when it's removed. I got a engine from a friend and the oil sensor was missing.

Hopefully a simple question... On my Predator Hemi build, how sensitive is the oil sensor? I've read that it will shut down simply by riding around corners. I've also read it will shut the engine down when doing wheelies? The wheelie thing I can understand, but shutting down while leaning into...

does anyone have info on low oil sensor bypass ?

I've searched and searched and found that I can easily remove the low oil sensor issue by just snipping the wire but I can't seem to find any info on what that small square module does that is connected to the oil sensor. It appears to me that after cutting the sensor wire I should be able to...

When my clone eng. is running and you lean the bike to the left,footpeg almost touching the ground , the engine shuts off. Is this because the low oil sensor leaves the oil in the crankcase for that short time? If so , how can I disarm the sensor and still use the eng. mounted kill switch?

Does anyone know where you disconnect the low oil sensor on a Predator 212cc engine? I have one on a buggy and it shuts off in curves, mainly when turning right very fast.:blink:

is there more compression when you seal the low oil sensor hole? After I sealed it up the pullstart is starting to kick back, starts up real nice though in like half a pull lol

removed the low oil sensor and internal governor, however need to know what size bolt i need in order to plug the hole the low oil sensor came out of... for shits and giggles i tried to start it up without bolting the hole and it didn't start... is this normal, will it start right up when i get...

Getting ready to do this mod along with others. (Don't have all the parts yet). I read on another site that you have to remove the LOS when using a billet rod. Uhhh... why? Is there a clearance issue? I don't see the harm in leaving it in there otherwise.... just disconnect the wire if need...

where is the low oil sensor at on the clones?

I have a new 6.5 HF clone, I just de-governed it and removed the low oil level sensor. What size bolt or plug do I need for the hole in the block? ..where the sensor wire went through. I'm at home, & the motor's at work,.. your answer will save me a trip across town to get my motor and...

Can someone verify that the easiest way to disable the low oil sensor is to just cut the wire going into the low oil sensor??

need an oil sensor for my 5hp B&s.:grind::censure::weld:

I am trying to run a Champion 6.5hp clone (that I bought at Costco last year for $100) for the first time. It runs for a few seconds on starting fluid, so I know that the ignition is fine. It seems like it is not pulling fuel, even though the gas tank is half full. I always start with the...