threw

home made mini bike

had my metal motorsports rivet for a little over a couple months now after trading some labor for it to a friend who bought it new half off due to a tag that said bad carb ! he never could get it running ! after dissasembling the carb i found some idiot had drilled down half through the jet...

caliper paint on moter gas tank was sand blasted resealed with gas proof sealer new jet carb to tank gasket pull cord plug moter was stripped down new seals gaskets compression test done at mower shop governor removed fits taco 22 perfact vary clean no scretches dents 3/4 shaft carb rebuilt push...

I know this is a minibike site but have a question i have a wheel mounted trimmer that has a 4or5 hp tec vertical shaft engine was using it yesturday got low on gsa stopped the enginre filled up tank started the engine it imeadiatlythrew the rod uot the side of the block no knock or noise...

Iv been wanting a nice simple cart for quite a while so iv been collecting parts and working on it the last couple weeks when i get the time. I rode it for the first time today. I started with a mower front end with low spindles and put some hand cart wheels on it. I made the frame with some...

Ok here is what I found today while taking the briggs apart that came on the bike I bought last night.... I figured the engine had to be pretty decent with a Hortsman intake, tilly carb, adjustable coil plate, alum finned valve spring cover... Well I knew I couldn't run the engine as is so I...