turning

I have a question,and I asked the same in My build off thread....Has anyone cut the top of a predator212 piston and used a .020" longer arc rod to end up with 0 deck height?....I have the tools to measure everything,just have to go through the r&r of the old rod/piston deck height,then the same...

I am going to pull a crank to have turned to 3/4. Its on a Briggs 6hp, its as now tapered, 4-1/4 long and is .872 in diameter. It has a 1-1/4 schoulder coming from the case to the machined shaft. How far should the shoulder extend beyond the seal to run a TC-2. How long should the 3/4 shaft be...

Who knows where I can get my gx390 pto turned down to 3/4"? Also possible balancing.

Hi All, I'm changing a bicycle trailer(very heavy duty) from one bike to another and now need to add 2 free turning front wheels to the trailer.I tried to figure out something by looking at wagons and go karts online but still not clear on what parts I need. One reason is the wheels won't be...

I performed a search on the forum, however did not find any previous threads. Pardon me if this has been discussed before.... The turning radius on the DB is like a greyhound bus! O.K., I'm exaggerting, however it is pretty bad (very wide). Has anybody performed any modifications to the the...

The kids I bought an old rare Victor minibike from had a 5/8" clutch and a 3/4" shaft so it looks like they peeled the shaft down to about 5/8" with a flat file!