Bonanza with a KT100

[1stlegendtx]

Bonanza Bronco Minibike I figured some one had to have done this.

 

[sharkybh]

SWEET I need that seat and gas tank..Thats right down the street from me..nice BIKE.
:weld:

 

[Old Bonanza]

I put it together.. we race karts for fun and needed a pit bike to get to and from the concession stand/bathroom/scoring tower during Road Race events.. and had the ex-RR KT laying around.. it is actually funner than h*** to ride. When the clutch locks up it pulls the front wheel right off the ground..
SharkyBH.. so which is it? Ohio or Washington? just right down the street fom me? About 2000 miles..LOL

 

[1stlegendtx]

I put it together.. we race karts for fun and needed a pit bike to get to and from the concession stand/bathroom/scoring tower during Road Race events.. and had the ex-RR KT laying around.. it is actually funner than h*** to ride. When the clutch locks up it pulls the front wheel right off the ground..

I thought about doing that but changed my mind.

 

[Old Bonanza]

Looks good!
That will open your eyes wider than any Briggs motor will do.. :thumbsup:
If that is a 4-hole can.. you can set the clutch to engage @ 8500-9200 and it will probably lay rubber on the street if you lean forward to keep the frontend down!!

 

[1stlegendtx]

Looks good!
That will open your eyes wider than any Briggs motor will do.. :thumbsup:

Yea, smells better to.

 

[Old Bonanza]

Ya.. nothing like race gas and caster in the morning:rockon:

 

[ScooterBoy]

Not quite done yet....But here's my current project. It's a mildly built Vintage Clinton E-65 Kart Engine. 7-8hp 7500rpm

 

[Old Bonanza]

Clinton

Looks nice Scooterboy, you going to run a Bonanza tank with that?
I see you are making some parts for these mini's, can you PM me a list of the parts you fabricate?
Thanks, Ken

 

[bayareaburrito]

Not quite done yet....But here's my current project. It's a mildly built Vintage Clinton E-65 Kart Engine. 7-8hp 7500rpm

Thats nice Scooter...I see a bunch a shinny chrome parts :thumbsup: