Anybody know the dimensions of the stock briggs keyway slot?
Im thinking it's 3/16" wide but Im not sure how deep.
I have a 5hp crank that has the wrong size pto shaft, its 7/8" and I am turning it down to 3/4" and will be cutting a new keyway on a mill.
I thought it would be easiest and maybe cheaper to just buy a different crank that has the 3/4" shaft, but this is a definetly a low time motor and I dont wanna throw in a used up crank.
Im thinking it's 3/16" wide but Im not sure how deep.
I have a 5hp crank that has the wrong size pto shaft, its 7/8" and I am turning it down to 3/4" and will be cutting a new keyway on a mill.
I thought it would be easiest and maybe cheaper to just buy a different crank that has the 3/4" shaft, but this is a definetly a low time motor and I dont wanna throw in a used up crank.