Anyone have a tape measure & a couple engines handy?
I'm thinking about shoehorning a big Predator into an '85 KX125 frame much like another forum member did a while ago with another dirtbike.
Looking for the general height, width, & depth (engine mounting base dimensions would be...
Can somebody give me the distance between the driven and driver (on centers) for this torque converter? Also, Is the driven mounted on a 5/8 shaft?
I'm trying to set up a system on a custom build but not use the backing/mounting plate. My jackshaft and engine will remain stationary...
Can somebody give the the dimensions of a newer Azusa Frame (the length).
If I could get approximately length of the top tube from end to end (outside of the bends) -and- the bottom tubes from the outside bend to the front edge of motor plate.
Blue=?
Yellow=?
Thanks for any info!
Could someone send me the dimensions of the sissy bar for a Cat Slingshot Mini? Also the angle the sissy bends up behind the seat if possible.
I need to make one so I can get my parts off to the chrome shop.
I still need some Kill Switch dimensions, so I can make one of them as well...
Hey guys, new poster here. Ive been reading the forums for quite some time now. Anyway, I am in the process of drawing up a custom mini bike in 3d studio max just to get a idea of how I want to build my mini over the coarse of the next few months. In order to do this, i need to know the size of...
Anybody know the dimensions of the stock briggs keyway slot?
Im thinking it's 3/16" wide but Im not sure how deep.
I have a 5hp crank that has the wrong size pto shaft, its 7/8" and I am turning it down to 3/4" and will be cutting a new keyway on a mill.
I thought it would be easiest...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.