Hello. New member here, and first time poster.
I have a a Tecumseh HS40 from a Bird minicycle I picked up over the summer. I took the carb bowl off to clean the carb, and was surprised to see the pink disk sitting in the bottom of the bowl. It appears to fit into the hole with the pink residue around it.
I need help putting this back together correctly.
Is the pink residue a type of glue? Do I need to glue it to stay in?
The disk is concaved. I am not sure if the disk should fit with the "dome" up, or down towards the bowl.
Any thoughts are appreciated; I would also appreciate a diagram of some sort. Thanks.
I have a a Tecumseh HS40 from a Bird minicycle I picked up over the summer. I took the carb bowl off to clean the carb, and was surprised to see the pink disk sitting in the bottom of the bowl. It appears to fit into the hole with the pink residue around it.
I need help putting this back together correctly.
Is the pink residue a type of glue? Do I need to glue it to stay in?
The disk is concaved. I am not sure if the disk should fit with the "dome" up, or down towards the bowl.
Any thoughts are appreciated; I would also appreciate a diagram of some sort. Thanks.