Looking for some Rupp parts

[conaway]

Need for my roadster2 (not a hustler) some parts:

frontlight housing complete

Rear light housing

Intake pipe for a hs50

Air cleaner housing

Exhaust pipe (black widow?)

TC cover

Throttle linkage

Rear sprocket #54

Seat cover brown

Fork cover 1971 up

Tank bushings

Fork strut seals

Gas tank cap

Decals

Thank you

Sacha

 

[jrzmac]

Need for my hustler2 some parts:

Thank you

Sacha

you sure its a Hustler2? and not a Roadster2! I dont think they ever made a Hustler2. also, the Hustler didn't come with any lights. maybe you could post a pic so we can tell exactly what it is?

1971:

1972:

 

[jrzmac]

wooops..... I just read your other thread. seems it is a Roadster2, not a Hustler!

 

[conaway]

My fault! You are right, it's a roadster2 :thumbup:

Sacha

 

[conaway]

No one?

Gesendet von meinem ST18i mit Tapatalk 2

 

[bikebudy]

e-pay # 390350369356

 

[conaway]

Wow, 130 plus s&h!? Think will be about 160$.

Sacha

 

[bikebudy]

310435981155 fuel cap

 

[David wulf]

I have a 54 tooth rear sprocket , also a angled intake . My sprocket fits the mag wheel .

 

[conaway]

Hello David, what exactly is a Mag Wheel? What are you asking for for the intake?

Sacha

 

[conaway]

After waiting over 5 weeks for the primary clutch I bought from an OldMiniBikes member I believe it will never arrive. Thank you a**hole...

So I am also looking for a primary clutch!

Sacha

 

[fistfullabar]

After waiting over 5 weeks for the primary clutch I bought from an OldMiniBikes member I believe it will never arrive. Thank you a**hole...

So I am also looking for a primary clutch!

Sacha

perhaps you should call them out and let everyone else know who not to deal with:sad:

 

[conaway]

And a tc cover mount bracket

Sacha

 

[fistfullabar]

And a tc cover mount bracket

Sacha

i might have 1 for ya:thumbsup:

44 year old "patina" or surface rust should clean up nice maybe get it chromed imp: its all yours:thumbsup:

 

[bikebudy]

I'm not sure what primary clutch you are looking for?

I have seen Rupp with Sachs, Fairbanks , Comet and other clutches.

Is your engine shaft 5/8" ? 3/4" ?

 

[conaway]

I'm not sure what primary clutch you are looking for?

I have seen Rupp with Sachs, Fairbanks , Comet and other clutches.

Is your engine shaft 5/8" ? 3/4" ?

Good question...I only know it as torque converter. Engine shaft depends on weather I use the HS 50 engine or the H50 I found. The HS50 has not the 3" crank and I have to measure. The H50 has a 10" diameter shaft and is 4.622" long.
But I am not sure if I should use the H50... it is really huge

Sacha