I finally got my clone engine to run smoothly. Starts up each time and runs like a champ. However, I noticed that with my current gearing 12t/72t it has amazing acceleration with plenty of torque, but the top end sucks. I think I'm maxing out at 20mph before the governor kicks in.
Debating if I should use the extra $200.00 I have to buy a TC2 torque converter OR upgrade to an ARC rod, ARC flywheel, and remove the governor?
What would be the best bang for my money if I want to reach 40 mph without sacrificing too much low-end torque?
Debating if I should use the extra $200.00 I have to buy a TC2 torque converter OR upgrade to an ARC rod, ARC flywheel, and remove the governor?
What would be the best bang for my money if I want to reach 40 mph without sacrificing too much low-end torque?