I bought a bc1300 bonanza I pulled the Go Power wheels and all 4 of the bearings sized and been run long enough the the bores were about 1/8" to big so I had to sleeve then Ken
Almost looks like those things have been sitting in water for a while or got wet and was never dried off. I wonder if a thin coat of anti seize would help to prevent the rust?
"China" bearings are cheap, poor quality however the clearances between shaft and roller, rim and roller seem not be as requested. I have the same issue in my Super Bronc, ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.