Trimming piston skirt

[Oldschool]

Anyone ever modify the GX160 Tier 3 long skirt piston to fit a GX200 clone?

Flat top piston the hard way.....
Could use some advice on adapting this piston and ring set to my clone

http://www.oldminibikes.com/forum/p...title=sacrifices-to-the-gods-of-speed&cat=500

 

[Solo Cali]

Anyone ever modify the GX160 Tier 3 long skirt piston to fit a GX200 clone?

Flat top piston the hard way.....
Could use some advice on adapting this piston and ring set to my clone

Message - Old Mini Bikes Photo Gallery

It can be done, but not worth the trouble imo.

 

[Oldschool]

Trouble is something I have at this point...
I got some feedback on the question from the 4cycle kart forum.

If you look in the piston section of NR's webpage you will see they offer a 9 gram lighter T3 " The only T3 that fits the Gx200 " Since Honda only makes 1 T3 piston with the 1mm rings I have too assume this modification is good for a 150 gram flat top.
http://www.nr-racing.com/raceparts.htm
Piston part number is ZH8-020 and rings Z4K-004 for anyone interested in ordering. Cost me 30 bucks with rings on the spot from a builder here in town.