Recent content by xBrent92

Before i decided to go clutch i had the tav-30 with the yellow spring on the tightest setting. pre-wound of course. The belt just sinks straight to the bottom of the pulley. This engine isn't weak. The mower probably weighs about 130lbs total. With me on it about 275 lbs total. The...

So my predator is pretty much maxxed out(on the excessive side) besides needing a big bore kit( which won't be done) and it is on a 6:1 gear ratio with 15" tires but the clutch gets hot quick. It's a regular $15 clutch. I haven't had a chance to wind out the gear yet but it will still grab...

A free one preferably. The last app i used(dashboard cam) didn't record audio just slightly choppy video and GPS speed. I have a record of 58mph to beat since i last modified and speed-ran the predator.

Where on the interweb sells stiff springs that will fit ? Must be at least twice as stiff as the yellow spring. I'll even cut on it to shorten it if i need to. Let me know, I really like my low to mid range power.

:) This motor is going in my john deere mower. Rear mounted though.

WAY too tight. This cam was the equivalent of adding nitrous to a stock one. You all know about that ,right? Increasing combustion that high causes the rings to butt together and scuff the cylinder walls? All this crap i've been receiving makes me think nobody does.

Just barely not as much as the first .In hope to prevent excess gas if needed.

IT WORKS GREAT!!! I am too excited. This is the first set i've ever filed and engine has absolutely NO blowby(i think) and can even hear as if it has more of a "punch" during each combustion cycle. So cool.

Hi, I would just like to say I have filed down my top two piston rings The second one not as much as the first for the engineering reasons you all should know by now.

My Answer : File piston ring. ---------To accommodate for the increased compression for .380" cam lift.

If someone would please so kindly send me one and i will be more than willing to test that claim. With video proof as well to go with it.

more horsepower= higher obtainable speed. more torque= higher acceleration to that speed. So if 44mph is the fastest attainable speed with the TAV-30 (which is 8hp rated) then a 40 series with a 16hp rating should allow double that .

Are you considering the 40series TC ? I am very curious as to how much of a speed increase would happen due to the higher horsepower rating compared to the TAV30.

I was considering donating but could you maybe do monthly subscriptions?

I used the vice and heavy steel mallet treatment the other day. Worked fine for me! Still a bit wobbly though.