builders

I have a bare frame,fork, and motor. The goal is to have a cheap mini to ride with my grandson. The question is; What would be the cheapest way to get all the parts to build a mini bike? I would like 8" wheels but I will go 6" if I have to. Azusa part kit? gather individual parts. Any bargains...

Can anyone out there reccomend a (REAL GOOD) Tec engine rebuilder for internal work and proper paint and stickers.

shortblock/parts lot for someone wanting to do some building. these are the parts from a swap I just did, I changed the block/piston/rod out on a bike a recently bought becuase it basically needs honed or bored out, it ran killer, but was blowing smoke. the block itself other than that shows...

you each need to reach around and pat yourselves on the back. to me your all winners. awesome machines one and all. thanks for letting me watch and learn!!:hammer::grind::weld::hack: :scooter::thumbsup:

I'm looking for dude who can rebuild my engine, do some spreed upgrades. I have a Kohler Courage 6.5hp clone engine. Who can I talk to on OldMiniBikes? Thx.

I have been in the Air Cooled VW aftermarket for 30+ years and I have talk to many street and HI Performance VW engine builders and that all swear by this oil for air cooled engines (that is what all these engines are): I know all 3x guys that came up with this blend of special oil...

I am thinking of building a drag bike this summer. I have no experience building a race motor what so ever. I can work on clones but I don't know what speed parts to put together to give me a good engine. I only want to do 75-80mph. What parts put together will give me a motor that will run...

whats up..i have a honda 6.5 GX200 Mini Bike that im looking to get modded..anyone in the Inland Empire on this site

I'm interested in having some work done on a 6.5 clone engine. My goal is to make 20 horsepower on 91 octane. I know there's AGK, NR-Racing, and Stout Racing Engines. Any others? Looking to spend less than $800.00 to make this much power.

I am about to build my first mini bike from scratch and I"m about through the idea stage. Here's my plan. I want a drag look lay down frame. I have found a local tubing supplier and I am going with 1 inch .120 seamless mild steel tubing for the frame. The complete real wheel assemble is coming...

I just installed a arc rod in a 6.5 clone with maybe three hours on it,I tq it all to spec and it seemed nice and tight,well I took the side cover off to re tq it if needed and I noticed side to side play in the rod:confused:There was NO play up and down but when I grab it I could move it right...