doodle bug

Hey guys total newbie Question I have a doodle bug that i call the grave bugger (grave digger is my hero!):thumbsup: i have an 8hp honda ohv and im going to implant it into my bug but it has a tapered shaft i need a new clutch or conversion kit for cheap im sixteen and have a job so if someone...

AGK just put up a walkthrough of a Doodlebug build up. It shows how to remove the stock 2.8 engine and install the new 6.5 clone engine. It also shows how to adjust the chain guard, wire the kill switch and set up the throttle. THANK YOU AGK!!

Ran into the local Tractor Supply store here in Galax, VA looking for snow boots for my daughters (and another snow shovel for the driveway). While there we noticed the little yellow Baja Dirt Bug mini bikes on display. They were on sale for $255 each and I mentioned to my wife we should buy a...

Just acquired a B&S Intek 190. Think the Model is 12HOHV. I got it free from a guy who just had it sitting on the side of his garage. Pulled valve cover and cylinder head. Needs some work obviously, but everything looks to be in good shape, valves aren't warped, push rods are straight...

OK guys, I've been asked to provide info as to where and how we set-up our DB with a rear hydraulic brake. Believe it or not I've attempted a couple of times to post this and after spending 30+ minutes typing it all out, it's disappeared. So I'ma try again!!! We got our rear set-up from...

The blank 80 tooth I saw online was like $35 :thumbdown: is there any reason why I could not buy this one Stub Axle Sprocket and simply redrill it? :hack: Also, is there enough slack in the stock chain or will I need to buy a new chain as well?

A week ago someone gave me a DoodleBug and I knida laughed. I asked him what it was called and he told me a Doodlebug, I laughed harder. After closer inspection and reasearch, I decided it had potemtial. I am mainly into Honda Z50 and CT70's, so if you have any questions about those I can...

I'm trying to get an idea of how many 6.5HP Doodle Bug swaps are running around. I also need to have an understanding of how many different ways the swap is performed & how this affects engine placement in the frame. It sounds like most folks drill the original engine mount plate on the...