drilled

as stated in the heading, looking for a 60 tooth sprocket 41 pitch.... also looking for a brake rotor to fit a peerless diff..

I got this engine 5yrs ago and have never used it, it needs a carb or a kit, gas tank is gone, and it needs a patch on the blower housing where the chipper's tank bracket came loose. I had it running back then but it had carb issues so those who know Tec engines can fix it easily. Perfect for a...

looking for the 5" aluminum drive wheel with the 6 holes drilled or not.

I'm in the process of spiffing up my '62 Craftsman Tecumseh aka the Flying Waffle and I ordered a few more OldMiniBikes Clutch Brake setup just to have around as I know I'm gonna use them. So I figure why not put one on. But then I notice to my astonishment that the holes are not drilled. I don't...

Any 3 hole 60 tooth sprockets for a 4" wheel ( 35 chain) out there?? I bought a blank and had it drilled and they screwed it up. Chain goes from tight to sloppy as you rotate the wheel. If I have to buy another is there a foolproof way to get them drilled perfectly? Thanks.

I got this motor in a trade a few months ago. Doubt I'll ever use it. The following is what has been done to the motor..... New hemi predator. Never started. Has been disassembled, clearances checked. Big end of rod opened up to .002+ oil clearance. Governor removed, low oil level sensor...

i found this medallion rattling around in a box out in the garage. the serial number is 58x8, i can't make out the x is. it was painted, drilled, scraped, scratched, but it survived. $25 gets it mailed to you by the united states post office. :drinkup:

I'm gathering parts for my Murray Track II. I am going to change the drive system to a 35 chain and sprocket, so I ordered a 66t sprocket but it was just a plate sprocket, so I drilled it some, just to make it look better. I used a 1&3/8" hole saw, a 1" hole saw, and a 1/2" drill bit. I think it...

I have a few bikes that I have within this week put predators on and one of them is on a mini chopper frame that didn't have room for their cleaner or muffler so it has a straight header and open air cleaner I rode it and is felt like it was missing and pulsing I assumed it was lean so I drilled...

I wanted to be able to see the shiny new Astro mag wheels I got so I drilled my sprocket with five 1 3/4" holes. Has anyone else done this and can I expect it to hold up to trail riding? Also, has anyone polished these wheels? How do they look when polished? Since the picture was taken I...