edelbrock

This is it! The last one I will ever make! This is an Edeblbrock head for the Blockzilla 1 that has been reworked to fit the Raptor and 5HP Briggs engines. Only for the cool kids! The holes were welded and re-drilled to fit. The mating surfaced was milled just enough to make it flat and clean it...

The son of the founder (Vic Edelbrock Sr.) of Edelbrock Engineering died on 6/9/2017 in Rolling Hills, California at age 80. According to Wikipedia, he ran the company from 1962. We owe a lot to this family for the vehicle performance we have today for their innovative design, engineering, and...

Ya say it isn't so? Edelbrock never made a head for the Raptor/5HP engines! That is correct! But as the enterprising stud that I am, I have made this all possible! I have taken the Blockzilla 1 head and had it machined to fit on a Briggs Raptor! This is fresh from the machine shop! These are a...

I did a search for this but didn't find anything. I have this Edelbrock Quicksilver carb that was made for a Yamaha YZF450R and was thinking about putting it on my 390. Yeah it is pretty big at 38mm, but would that make it too big for a 390? The 390 will be built, but not all out. Or...

Have you guys seen this! The Story I found for it! Not alot of info but sweet as hell! This is a mini twin built by Jeff "JESSE FLOYD" Wallace with some help from Glenn Gulledge, and Mike Crawford from North and South Carolina. They started with a Reaper frame and two 10 horse...

So I've had this Edelbrock Blockzilla cylinder head (part #3610) kicking around for a while, and I compared it to the two 5hp Briggs motors I have and I noticed that the bolt holes do not line up. These motors are dated 1991 and 2000. Will this head ONLY fit a Blockzilla, or will it fit a...