gx140

Honda GX 140 engine installed after I took the GX160 off for another minibike.

I have the high torque version of the CL1 cam and noticed the cam card recommends only 10.5 LB valve springs. Its the hardened version. That seams pretty light. I am rethinking my build and kinda thinking of trying the GX140 springs as NR says there 16# will these run to the 6K that I am going...

Genuine Honda 140 E-Tubes $6.00 Shipped anywhere In the US Free PM Or E- Mail Me astrowrench@gmail.com

Genuine Honda 16166-ZE1-00* These are the real GX140 Honda E-Tubes$6.00 Shipped anywhere in the Cont. U.S. Paypal or M.O. pm me or astrowrench@gmail.com

I recently bought a kit from NR Racing and it came with a .37 jet. was wondering if I can actually use it with the 140 or if it is overkill. Any input is appreciated, thank you

So I have a honda gx140 and the problem is when I try to rev it some times it will rev up but that is rare it usually just kills but it will idle. It idle up and down also. Could it be lack of compression?

View image in gallery View image in gallery 5hp Honda motor. "The Good" it runs excellent, has the throttle hook up already installed. no governor,no oil alert,they have been removed. stock bottom end internals,same stroke as a GX160 just smaller bore. GX160 14cc clone...

25$ shipped i changed my carb to a mikuni and this one barely has any use, great power gains, comes with carb spacer and choke lever too

GX140 14cc head. Same as GX160 just smaller valves. Wanted to install on one of my Predators but do not have time to clean and get into another project. What you see plus carb studs. Springs are new 18lbs. $35 plus shipping. Located at 10509 Brewster, NY

Hey guys I have a GX140 laying around and I was wondering if any of the parts on it would be good for my GX200 build. I figured if anything it would just be the head and/or the ignition. I've read that the head doesnt have enough material to open up the ports enough to flow well. What about the...

i have a honda gx140 motor oil alert system has been taken off along with the governer assembly. the motor came from a old compresser was not running when i got it. i replaced the exhaust carb rebuilt the head valve job rockers push rods valve lash is set proper along with the timing. i am...

does it make any noticeable gains?

Are there any performance parts for a GX140 available? I can only find parts for the gx160 and gx200 ect

Hello all, I was tearing down my gx140 today to get a a list going for my mini. So I removed the oil sensor and took the governor parts out. I noticed as i turned the crank there was air seeping by the piston into the crank case. i could hear it hissing. Is this normal for these motors or...

Are any of the parts on a GX140 interchangable on a 160 or 200? They're obviously similar, but what are the differences?

Can any one please tell me how many holes a gx140 emulsion tube is it 8 medium holes, 4 small holes and 2 large holes at the very end? THANKS IN ADVANCE

Will a 6.5 clone air filter and housing fit a Real Honda gx140.