I am about to stretch a DB-30 and would like to know the thickness of the main frame tubing before i cut it (I'm guessing it is .060), so i can buy the tubing I will need for it!
If it is .060 than 3/4 should slide in fairly firm! Thanks, Paul
I cleaned out the carb on my Tecumseh H35 and was about to be finished until the main jet broke during installation. Luckily it broke at the hole going through it, so I was able to unscrew it with a flat head. As I was figuring out my plan of attack, I remembered I had a Briggs and Stratton...
Ok, just rebuilt my carb with a new rebuild kit. The adjustable main jet drips fuel. I tried different o-rings, stacked two o-rings. Any input on curing this problem?:confused1:
I need other # main jets for my engine. My only mods are a UNI filter and a 1" diameter / 12" long custom header and I know its gonna get lean. Any help on where to get jets would be great...Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.