Not too, too sure what frame i have exactly. I believe its a bonanza bc 1400 and ive been looking for a swing arm for some time. Let me know what you guys have, or if someone knows how to fabricate one. Thanks in advance
Hello all,
Looking for pics or information on how the swingarm mounts to frame. I have bearings that seemed to be welded to the cross pipe on the frame. Pics I see seem to show a through bolt and nut and washer ?? Also on the jack shaft how is the mtg. there ? Thanks!!
Mike
Trying to help someone out that wants to restore his bike, He has a 1968 TT500, sometime over the years though It apparently needed the frame fixed or something and a 1969 frame was used (all other parts are '68) far as I know the frame interchanged between all models for that year that were...
I am trying to figure out what is the best way to run a swing arm and the jackshaft in one mount. Along the way the Bonanza mounts work/look that OldMiniBikes sells. Is there a rule of thumb for the 2 points being to far away from one another? Or do they need to be as close as possible?
I fell like I...
$100 and shipping.
Exact year and model is unknown.
Previous owner added foot pegs (something must have happened to the originals), and they were put on crooked so I took them off.
They also welded some angle iron to the bottom of the frame (see 2nd picture), I was able to remove the pieces...
Hello members, I'm trying to save my swing arm, it was really bad!!! It had several scabed on pieces and gobs of something that almost looked like weld. Any ways does anyone have a good pic of one so I know what it is supose to look like? When these were made were the two stamped parts of the...
Rupp Roadster 2 restoration. The swing arm bushing is pinned/staked, making it difficult to remove the outer bushings. By drilling out the pin stake notch the bushings can be easily removed.
Does anybody know where to buy the retainer that goes on the swing arm of bonanzas? All the ones from OldMiniBikes warehouse are too big in diameter. Thanks
I'm looking for a Bandit (not Rupp) swing arm or someone who can provide these center to center measurements so I can either modify a swing arm I have from another mini bike to work, or build it from scratch. Photo is the correct swing arm.
I need a Bandit Mini Bike swing arm (not Rupp), or if anybody can provide these center to center measurements so I can modify another swing arm or make one from scratch.
Edit: This was my first post. It was supposed to be in the wanted section! I can't delete it so I'll repost there.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.