tighten

I recently built a clone with all the goodies , cam, springs,arc rod,flat top piston, anyway I ran the motor for like 20mins then I notice it was leaking oil out the side cover gasket. I removed motor from the bike and broke the engine down , I wanted to check torque on rod & switch cam &...

I picked this up for $175. It's complete and runs great with the original 3.5 tecumseh. There is about 1/8 inch of side to side play in each side of the rear axle. Is that normal or should I tighten the axle bolt to close the gap? Not sure if my picture worked. Thanks.

A friend of mine picked up A Alexander Reynolds minibike on Craigslist.since we are having a heatwave in Cleveland we thought we would take it out for a spin.with the throttle wide open the chain bounces aggressively and eventually falls off. We moved the engine forward to tighten the chain (not...

Just installed a new Hilliard clutch to my 6.5. It is only held on by a single bolt thru the end of the crankshaft and a lock washer. Problem is....I haven't figured out how to tighten the bolt enough as the center of the clutch starts to spin. How do you hold that sucker still?:crying: