looks good but yea it should have some more air. Where did you get the cup from to make it? Heres some iv made. 3 or 4 of them are old pulley guards from snow blowers that i modified
I made one out of an old 4 cylinder engine's timing belt cover. Cut it down and added a few brackets. The other I got at OldMiniBikes warehouse which is sturdy, easy to mount and doesn't cost much.
thanks! i love it. Everythings old and rusty on the bike. i kept getting hot oil up the back of my leg and i had the old rusty oil can i didnt know what to do with. match made in heaven :laugh:
george3 i do have some pictures of it before it was finish. i just use part of a stainless cup/bowl and welder it to a piece of metal that i fab up to cover the chain going back to the rear sprocket:thumbsup: and it was for a acme frame. very close looking to a newer style manco bike.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.