Hello, I’m currently building a 212 non hemi and have ran into some issues with my piston to Valve clearance.. I aligned the cam dots and put the side cover on, put in my pushrods and spun the engine over and my piston is hitting the valves, I personally think my pushrods are way too long (...
Hello All,
I need some help and advice from the masters on this page. While I am not a novice when it comes to small engines, this is the most in depth I have gone working on one.
Here is what's up: I got this 70s ARCO E-Z Rider from my mother in law 13-ish years ago. It is a H30 -35176J -...
Hello everyone,
I'm new to this thread and to minibikes in general, so I'll try to include as much info as I can.
I have a Coleman CT200u 196cc 6.5 HP minibike, that is about a year old and maybe about 25 miles on it, so relatively mint condition.
For the first few months when I rode it...
I recently purchased a baja mini bike db30 the guy told me it had sat for 2 yrs so first thing i did was drain and fill the fuel and checked the spark plug, afterwards ot was able to start but then the engine would only run with the choke on, i then removed the carb cleaned it completely and it...
Working through Efenel Mini bike project and trying to decide on a engine that will allow me to ride in different mini bike events, but also something my 11 yr old son could have fun on.
The current motors I was considering were a Predator, Briggs Animal 206, or Briggs Raptor model 133230...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.