I have a stock db30 engine (98cc Lifan flathead) that I would like to extend the intake on. I'm wondering if anyone knows where I can get a flanged elbow that will fit the intake on this engine, which I can use between the carb and the engine. There are several reasons I want to do this. One...
Tried a bit of ghetto for my Atlas resto/rat build.
The exhasut extension is chorme plated brass tailpiece for a sink from home depot
The bell fits over the standard hot dog muffler and gets held in place by the pot metal nut that comes with the tail piece. Ran it for about 10 and it held...
Does anyone make a crankshaft extension with a keyway that would screw into a 3hp that has a 1 1/4 long by 3/4 inch shaft. I do notice that Briggs makes a crankshaft extension but no info of what engine it is for (Briggs & Stratton P/N 691779).
I have been looking for a 3hp with a 2 1/4 inch...
Anyone into making seats any more? I would like a seat extension for my new style dirt bug. I would like to add a small seat to the back. I tried to upload a photo to show but I did not work. If anyone is up for the challenge I will email you a picture. Thanks.:scooter:
I bougt a Biggs 5hp for my Boonie Project. The motor came off a tiller and has a shaft that is 1.25 inches. If i reverse the clutch (gears in) i can get the cluch stable enough. Do I need to extend the shaft to go all of the way through the clutch? if so any ideas?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.