idea

Being held in so folks don't need to read the entire title or the content to know where the meet is being held. :smile:

https://www.youtube.com/watch?v=n2Wp-7kqEKI

Plenty of extra stuff added on but not sure what it is. Picked up off craigslist.

Hello, New here. I found this in a crawlspace. Through a simple Google search, I found nothing even close.

ok long story short, engine has no governor, billet rod, flywheel, etc, i will be using the stock throttle linkage with slight modifications but the real question is I don't have a conduit holder and was wondering if a substance like QUICKSTEEL/STEELSTIK would work to hold the end of the...

Any ideas?????

I'm thinking the roll cage is added and I'm not sure if the rear wheels would be original or not but I'm stumped.

Any idea what this is almost looks like it has a Honda trail front end.

https://detroit.craigslist.org/wyn/snw/5835407222.html

I'm thinking for the future on my Rupp that a GX200 would probably be the best setup. Its already got a GC160 which runs fine for now but I don't think it will hold up to much use with the aluminum bore. I been watching craigslist but not seeing any good deals. I noticed that they sell bare...

Not pretty but but it was cheap:) any idea what it is?

Hello All. I wanted a different way to put the choke lever on a clone carb without the bracket so I could choose whatever air cleaner I wanted....and here's what I did! I drilled an tapped the choke boss for a #8 screw and drilled a corresponding hole into the top of the choke lever. I used a...

not finding an exhaust I liked,not being a welder I usually have to think of alternatives..I took a 3/4" floor mount a 3/4" 90° elbow and a Briggs style muffler...used cut off blade,shaped the floor mount,had to slot and grind sides of flange a little so nuts would clear...rode with shorts...

Hello - Picked up these 2 in a barn, planning on rebuilding and using them at the track as pit bikes. Planning on using Honda GX270 go kart motors (since I own an indoor karting track and have a few hanging around. Bronco perhaps? They are pretty rough and incomplete but the frames are in...

Greetings from Ireland. This has a 3.5hp 4 stroke Clinton engine . Any ideas??it was baught in Germany and is now in Ireland. The trottle and break are opperated by the pedal

Any idea what mikuni pilot jet this is? It's a #60 pilot jet in a carb I ordered and I need a #30. Its from a vm26 genuine mikuni but im not sure if its a 26-606 or a 26-8074 mikuni and if that would make a difference. Apparently at tboltusa their genuine vm26 pilot jets won't be compatible with...

I dont think ive seen this anywhere and maybe it would belong in the Tech section but we have a lot of very skilled craftsmen in this group. Why dont we have a tap or Sticky post with some of the skilled people who are willing to make and sell their products? I know there are plenty of people...