idling

Yo peeps, Saturday night I got this gorgeous hunka steel going. Installed a brand new carb and cleaned points. Had good spark so I didn't mess with the timing. Prob is I can only get it to start by putting my hand over the muffler (not installed in this pic). I put a clear fuel line...

Hello my engine is a t 212cc predator. When it starts you must pull the throttle as well as pull. The choke is on. Only thing is when u let go of the twist throttle it kills itself. Sounds gret when the throttle is being pulled though Sent from my iPhone using Tapatalk

This is an approx. 2 year old Tec 0HH60 6 HP engine that came on a used mini bike I purchased. It has the carburetor with the infamous "primer bulb":out:, however that is not the problem at this time (yet?). The engine has good power, and runs very smooth other than at low idle. I believe that...

I just swapped out a new doodlebug with a bad carb (old body style) for a new style db30 that seemed to run great for the first 30 minutes. Before riding the bike for the first time, I oiled up the clutch bearing per the advice of the mechanic from Northern Tool. The bike ran great for my...

Hello, Ive been having some trouble with a 6.5 clone I built, it seems to rev on its own even at choke and wants to take off when i un-choke it , here are the mods ive done: removed governor #90 jet header air filter I am using an after market linkage kit for my throttle, here's the...