lighting

I've been searching for a 5/8 shaft lighting coil for a Tecumseh 3.5hp engine from the 1960's-70's era...Does anyone have one for sale? Thanks!

Hi. I have a rare Cyclops minibike lighting kit for sale. I'm located on Long Island. The kit is posted on eBay. It is an NOS kit, very rare. PM me for details. Thanks. Novadose74

I need a lighting coil stator for a tecumseh hs40

What is the difference between the HS40 and the H50 lighting coil besides the two and three wire set up. You should be able to swap them right?

I have a decent H50 with lighting coil for sale. This originally came off from a Harrison Wildcat 500, so it never had an attached gas tank. The motor was rebuilt by the previous owner (new rings), I had the valves done because I couldn't get the motor to run right when I first got it. Now...

Ok fellas pretty simple question. I just got a Tec with a lighting coil. The wires and plug are there. One red, black and green? I think. Please tell me what wire does what? Thanks

Hello All I need to thin the herd, so I am offering this. I acquired this Briggs 5HP I/C on a trade for some parts. I believe this was a military motor based on the color. It originally had a carb heater attached to it, but it has been removed. I have no history with this motor and I have not...

I pulled it from a junkyard motor.. Lighting coil works, starter and relay works, switch (worked) one way rectifier resistor works.. I had everything working, then the engine kill wire fell off from the ignition switch and needs to be soldered back on.. :angry: So I stopped wasting my life...

So, i found a Honda GX160 in the aluminum dumpster at the junkyard.. Looks like Smokey was the one who unloaded it, judging by the excavator damage to the sheet metal.. :glare: It looks as if the (stuff) is there and good, original key and all.. It was zip tied to the shroud.. :confused: I...

tecumseh hs40 with 400 series driver and lighting coil

tecumseh mini bike engine from speedway scorpion

tecumseh mini bike engine from speedway scorpion

tecumseh mini bike engine from speedway scorpion

I have the POWER! I purchased a flywheel and 2 lighting coils on ebay that are listed as fitting a GX160/200. I paid like $42 I think. The flywheel came with a starter ring attached. I had to remove it in order to clear the ign. coil. I then tapped the existing holes with a 6mmx1.00 tap and...

On an engine with a small 3 amp lighting coil with a single wire... How would it be wired to a light? Would I just run the wire to the + on the light and ground the - to the engine block? I am refering to a Honda GX with the single wire. Thanks,

Finally finished his engine that was gonna go in his 2013 build off bike. It is almost metal flake LOL ! Yes Minibike Paul the Skat Kitty block is at the boring shop.

This wont last long....Maybe someone here needs one? Vintage Kart Mini Bike A West Bend 510 580 700 Die Cast Exhaust Header | eBay

Hi everyone I just p/u this 8hp for a Sportsman trail scooter that I want to try to put together. When I p/u the engine I did not know it had a lighting coil on it. So now that it has power I want a starter and lights it does have a spot for a starter. Does anyone have some kind of wiring...

untested lighting coil, it has spark but had the wrong flywheel to test lighting. obviously no flywheel. 35 shipped

Wondering if they are the same for the 2.5 - 4hp engines. I have a lighting flywheel that has damaged fins from an H25. Anyone have a good one for sale?