position

Alright everyone is been a long long time since I posted on here... My son has the green doodle bug. I upgraded the engine yo the HF blue 6.5 hp... It's been sitting for at least a year with fuel in it... I drained the old fuel and put new fuel in it... Well it starts fine when the choke is on...

Saw this and thought it was moderately funny, but worth sharing. How to Ride Bitch - Video - BikersPost

I looked around on the forums and couldn't seem to find a tutorial for this. I recently picked up a dial indicator and wanted to double-check my method before I wrenched the flywheel back down and there doesn't appear to be a thread for it. I doubled checked with a seasoned Tecumseh mechanic and...

Dont know if anyone needs it or not..... Late version from around a '95 shroud/pull start/backing plate and fixed postion throttle. The recoil is they type thats pre drilled and setup for the optional bolt on external lighting generator (if your lucky enough to find one.) Shroud is clean...

Ok hello to you all. this is my first post. I consider myself a very good home mech. I have pulled trans and engines, BUT OMG this pred engine is driving me nuts. history: I got a go cart from a friend, for a father son project. It has a pred 212 engine. It fires up on the first few pulls, but...

what are your thoughts on a long intake it will be about 12 inches to position the carb on the front side of the engine 212 hemi

what are your thoughts on a long intake it will be about 12 inches to position the carb on the front side of the engine

line up the push bolt with the rear oil drain plug on a Briggs engine or any engine with a rear oil drain plug at about the same height it should work on the tecumseh HS engines but not the H engines unless you shim it higher drill two 1/4" mount holes in the motor plate and bolt it down with...

I know this is not a mini bike question, but who else can I ask!.. In California we have the new smog engines and the gas tank is very large. These engines like the Predator will not fit into the old fun karts unless the engine is to the rear of the drive sprocket as the tank hits the back of...

When installing a magnet for a vapor, on a Puma, I would like to put the magnet right under the lip of the rim where the tire meets the rim. When I JB-weld this magnet on, does it matter how the magnet faces the sensor? As in, can I just put the magnet on the rim how it is naturally...

For Sale Very Nice No RUST!! 5 position shocks.. These appear to be brand new never mounted 11" center to center mount. $65 shipped