governor hole ?

[motown]

Iv been told a few things so I thought I'd ask on here before I go ahead and do it. I finally got around to swapping all my parts over to my new block rod piston flywheel all the goodies. I was gonna put a bolt and Teflon nut to plug the hole from were I removed the governor but I've been reading and some say just a self tapping screw will be good wat works best to plug it up

 

[CarPlayLB]

on 6.5 Predators I tap the holes 1/4-20 and run a screw in them with Loctite,,,no problems!
I run the bolts in from the outside of the block. I don't like the screw/bolt scenario...there can be failures if they break free!

 

[vwfan79]

I always use a self tapping bolt and some rtv.

 

[motown]

Thanks for the info guys I'll grab a few self tappers at the hardware store tommarow

 

[cheezy1]

I use fender plugs..plastic ones. Been using them for years on those blocks. Never leaks.

 

[Bonanza BC1300]

Some aluminum weld?